1996 Ford Aerostar/Ranger/Explorer Camshaft Position (CMP) Sensor REMOVAL AND...
download CAUTION: Syncro Positioning Tool T95T-12200-A (3.0L, 4.0L) or T96T-12200-A (5.0L) must be obtained prior to installation of the replacement synchronizer assembly. Failure to follow this...
View Article2001 Chrysler Sebring LX POWER WINDOW MOTOR Removal
download NOTE: This procedure also covers condition where power window cables become disconnected. Removal Remove window regulator. See WINDOW REGULATOR . Remove 2 screws attaching metal cover to power...
View Article1999 Ford Taurus Camshaft Position (CMP) Sensor SHO Removal Installation
download Camshaft Position (CMP) Sensor SHO Removal 1. Disconnect battery ground cable (14301) . Refer to Section 14-01. 2. Remove the engine appearance cover. For additional information, refer to...
View Article1998 Ford Windstar Strut and Spring Assembly REMOVAL AND INSTALLATION
download Removal 1. Raise the vehicle on a hoist. 2. Remove the front wheel and tire assembly. 3. CAUTION: To avoid damage to the 6mm drive hole in the front stabilizer bar link ball stud, do not use...
View Article2003 Lexus GS 300 PARK/ NEUTRAL POSITION SWITCH MALFUNCTION
download Park/neutral position switch detects the shift lever position and sends signals to the ECM. The ECM receives signals (P, R, N, D, 4, 3, 2 and L) from the park/neutral position switch. When the...
View Article06-07 DODGE CALIBER/JEEP COMPASS, PATRIOT; 07-08 WRANGLER CRUISE CONTROL SWITCH
download REMOVE THE NEGATIVE BATTERY CABLE BEFORE INSTALLING THE CRUISE CONTROL COMPONENTS FOR SAFETY PRECAUTIONS. FIGURE 1. 2. JEEP WRANGLER APPLICATIONS: REMOVE AIRBAG BY USING ( TRIM TOOL TO RELEASE...
View Article1995 Ford Thunderbird Spring REMOVAL AND INSTALLATION
download Removal 1. Raise vehicle on hoist. Refer to Section 00-02. 2. Remove rear wheel and tire assembly. 3. Remove rear stabilizer bar link and bushing link nuts at both ends of rear stabilizer bar...
View Article2005–2009 Toyota Tacoma Rear Suspension Squeak Noise
download 2005 – 2009 Tacoma Body Type(s): Access Cab, Double Cab, Regular Cab Drive Type(s): 2WD, 4WD Engine(s): 1GR, 2TR Transmission(s): 6MT, 5MT, 5AT VDS(s): JU62N, KU72N, LU42N, MU52N, NX62N,...
View Article1998 Ford Windstar Camshaft Position (CMP) Sensor REMOVAL AND INSTALLATION
download CAUTION: Prior to removal of the camshaft position sensor (CMP sensor) (12126) , set cylinder No.1 to zero degrees top dead center (TDC) of compression stroke. Then note the position of the...
View Article1995 Ford Mustang Camshaft Position (CMP) Sensor Removal Installation
download 1. Disconnect battery ground cable (14301) . 2. Disconnect fuel charging wiring (9D930) from distributor stator (12A112) (camshaft position sensor). 3. Remove stator camshaft position sensor...
View Article
